Symprex Email Signature Manager, v7.2.0

Manage Signature Injection Rule

The Manage Signature Injection Rule dialog is used to create or modify a rule for injecting a mobile device signature into an email. It is opened using either the Add... or Edit... button on the Mobile Device Signatures dialog.

 

Injection Rule Dialog

 

Each Signature Injection Rule has the following properties that can be modified:

 

Name

Description

Name

The name of the rule.

Description

A description of the rule.

Text to Replace

The text in the email to be replaced by the signature.

Rule is active

Specifies if the rule is active; only active rules are applied when processing emails.

Apply rule to HTML messages

Specifies if the rule is applied to emails formatted in HTML.

Apply rule to plain text messages

Specifies if the rule is applied to plain text emails.

Rule is case sensitive

Specifies that the match on Text to Replace is case sensitive.

Check if there is a new line before the matched text

Specifies that new line must be present before the Text to Replace for it to be considered a match; if no new line is found then the text will not be replaced.

Check if there is a new line after the matched text

Specifies that new line must be present after the Text to Replace for it to be considered a match; if no new line is found then the text will not be replaced.

 

Once the rule has been configured, click the OK button to apply the changes and close the dialog, or click the Close button to close the dialog without saving changes.

 


Copyright © 2016 Symprex Limited. All Rights Reserved.